CabiFit - Passenger Lift

Main features

Lifts designed in compliance with the CABIFIT model arecharacterized by the machinery (gearbox, control panel, panel with main and lighting switches) contained in a cabinet. A very wide range of solutions, with various loads, dimensions, and car finishes, landing and car doors type and dimensions, are available.

The machinery occupies an area of less than 0.4 m2 (width 950mm, depth 400 mm), instead of about 4 m2 for the traditional machine room.

The cabinet height is 2 metres, which is the minimum height for the area where maintenance operations are carried out.

It can be located at any landing. The cabinet dimensions are always the same, regardless of the installation features (load, speed and number of stops). Gearbox and control panel components are very close together. This makes assembling, maintenance and rescue procedures easy.

Most of the lift load rests on the car and counterweight guides. Load bearing beams to fix onto the shaft walls are not required. As for ELEKTROFIT models, owing to the frequency control system, which uses a high quality inverter, a high standard of ride comfort, reduced current consumption peaks and consequent energy and money saving, reduced mechanical stresses and reduced temperature of the gear motor are obtained.

Safety

The cabinet can be opened only by a specific key. When it is open, it clearly indicates the area necessary for maintenance operations and rescue operations.

Compared to models with the machine in the shaft, the machine maintenance operations do not require access to the inside of the shaft.

Comparing this model and those with the machine in the shaft headroom, there are several benefits for the installer and maintenance operators: the assembly is easier because it is nearly the same procedure as a traditional lift with the machine room, the gearbox is fixed on the landing floor and rests on a frame, therefore its position is extremely stable and maintenance operations can be carried out from the floor.

The rescue operations can be carried out by any trained person and these are always possible in any fault situation.

To see any of our products in action, call us on 01200 405005 or email info@axess2.co.uk.